The TMUSB Device Driver is installed automatically when installing the Advanced Printer Driver. This module is a revision program for the USB communications department of OPOS, OPOS.NET, APD, JavaPOS, TM-J9000/J9100 Driver, TM-S1000 Driver and some utilities.
This is a USB device driver for EPSON TM/EU/BA Series. TMUSB Device Driver Ver.7.10b can be installed on OS earlier than Windows 10. * This phenomenon does not occur in printing using the device fonts or the commands.This download page is for TMUSB Device Driver Ver.8.00b that can be installed on Windows 10 or later.If printing with non-square resolution setting, print result becomes stretched vertically or horizontally.(4) Support of Dot impact printer drivers for Windows 8.1 (vi) The timeout error (ERR_TIMEOUT: -70) will be returned when specifying the "Number of line feeds": 22(16h) by BiGetCounter() or BiResetCounter().(v) The image data setting by grayscale mode cannot be printed.(iv) In case of printing the 2-dim code in text mode which is not supported by firmware (Type1), it is NOT printed (ignored).(iii) In case of printing the MicroQR Code in text mode which is selected by "model2" on UI, it will be printed by model2 (not MicroQR Code).(ii) In case of printing the barcode in text mode which is not supported by firmware (Type1), it will be printed by garbage prints.(i) User can not print the intended image/content by setting out of range in layout setting (between 0.0 to 1.9mm each margin) because firmware (Type1) does not support these margins.(3) In case of using by combination of TM-L90 Label Driver and TM-L90 Type1 (Types except for TM-L90 4xx series), the following functions do not work. (2) Please use the same version of EPSON Advanced Printer Driver for each host when a network printer is shared among two or more hosts. (1) When using the BA-T500II, make sure to use the printer driver for the BA-T500II. *1 There is a need to introduce the components necessary for operation of the driver.įor details, please refer to the installation manual. Windows Embedded Enterprise (32/64 bit) (*1) Windows Embedded for Point of Service (*1) Please see the following "Support Models List.pdf" file. Fixed a bung that, when receiving response data divided from the command, the StatusAPI may not notify the application correctly. Fixed a bug that, at PC startup, the command responses from the printer may be processed incorrectly and therefore the printer remains unavailable. Fixed a bug that, when the status was checked with Status API right after printing, it returned the Power-off status.
Added support for Windows 11 21H2 (64 bit) In addition to ordinary Windows printer driver functions, this driver has controls specific to POS.
0 kommentar(er)
